GAL - KOLORCURE ANTI-BUBBLE #2

If small pin holes or an orange peel occurs on surfaces that are hard to wet, add 1 to 5 % by weight of Kolorcure Flow Promoter. This product readily stirs into the various Kolorcure inks or Lustercure coatings.

Kolorcure Anti-bubble aditive is a debubbling and flow control agent for use with Kolorcure UV curable inks and coatings.

While all Kolorcure screen inks and coatings are supplied "ready to use," application conditions sometimes arise (very high speed screen printing) when the addition of a small amount of Kolorcure Anti-bubble Additive is required.

NOTE Kolorcure additives become an intergral part of the cured ink or coating film. The use of excessive amounts of these products may affect cure speed, flexibility or adhesion. Once the Kolorcure screen ink or coating has had an additive added, the user should verify that the product still performs to their satisfaction..

WARNING: The use of goggles, gloves, and protective clothing is recommended. Avoid prolonged breathing of vapors. Contact of liquid material with the skin may be irritating; wash exposed area thoroughly with soap and water. Contact of liquid with the eyes may cause injury - effects may be delayed; flush eyes with large amounts of water for 15 minutes and call a physician. Do not take internally; if ingested, induce vomiting and call a physician. Like most polymers, the properly-cured resins are considered tobe largely inert.

Based on our experience, we believe that the above information is accurate, but we offer no guarantee as to the use or application of our products or of this information.