QT - #CANDOC SG VINYL EXTENDER

Vinyl Extender Q

SPECIFICATIONS:

USES: Flexible pressure sensitive vinyls: Cast and calendered outdoor films such as Scotchcal, Avery, Meyercord, General Formulations. Rigid sheet vinyl and foamed vinyl graphics panels: Sintra, Trovicel, Celtec, Vekaplan. Also recommended for Lexan, Makrofol and other polycarbonates, some acrylics, and other substrates with vinyl coatings.

FINISH: Dries to a flexible, semi-gloss finish.

COVERAGE: Averages about 1200 sq. ft. per gallon.

OPACITY: Excellent opacity for most colors.

DRYING TIME: Air-dries in approximately 30 minutes; forced drying time is 30 to 60 seconds at 100-120°F. Low lifts are recommended.

SCREEN FABRIC: Use a 160-300+ mesh for conventional printing.

SCREEN COATING, FILM, BLOCKOUT: Direct and indirect photostencils, or water soluble, knife-cut stencils are suitable.

MODIFIERS: Thin with SGV-701 or SYS-1920. To subdue the gloss finish, mix PT-83 Flattening Powder with SYS-1920 to a paste consistency and add to the color. To improve ink flow out use SGV-11335. Under hot and dry conditions, us SGV-720 Retarder sparingly.

ADHESION: Excellent on most vinyls.

WASHUP: Use SGV-710, or SYS-1911 Vinyl Washup or biodegradable washes 2500 or 2510 screen wash gel.