Dark Brown

Features:

  • Unique suede finish.
  • Simulates real leather.
  • All quantity breaks are in total gallons (not quarts) of ink assorted

Description:

Union Ink's Suede Plastisol Ink combines an extremely matte finish with a fuzzy texture and a slight puff. The resulting print is almost indistinguishable from suede leather in texture and appearance. Suede Plastisol can also be used to simulate sand or s tone and other unusual and subtle special effects. PLSE Series has Phthalate, and NPSU Series is Non-Phthalate.

Read More

SPECIFICATIONS:

USES:Union Ink's Suede Plastisol Ink combines an extremely matte finish with a fuzzy texture and a slight puff. The resulting print is almost indistinguishable from suede leather in texture and appearance. Suede Plastisol can also be used to simulate sand or s tone and other unusual and subtle special effects.

PRINTING INSTRUCTIONS: Print with a smooth stroke for an even suede look and feel. Avoid printing over a cured underbase or printing with the print-flash-print technique. You will get best results when printing Suede Plastisol last. Multiple colors of Suede can be printed wet-o n-wet. Always test new designs before production to determine the best printing procedures.

OPACITY:Suede Plastisol ink has good opacity.

CURING: Suede Plastisol inks will not air dry. They must be heat cured. These inks will fully cure and withstand repeated washings when the entire ink deposit reaches 310°F (154°C). Curing can be accomplished with the use of a conveyer dryer, flash curing unit, or simple infrared heater. Proper curing is extremely important. Poor washability of the print can generally be traced back to under-curing!.

SCREEN FABRIC:Print through a 110 thread/inch mesh (43 thread/cm).

SCREEN COATING, FILM, BLOCKOUT: Use water soluble hand-cut, direct emulsion photo screens and almost any blockouts with this ink.

MODIFIERS:Suede Plastisol inks are supplied ready to print. Since plastisol inks "body up" as they sit in the container you should always stir the ink well to determine the actual printing viscosity before adding any reducer. Reducing the ink usually redu ces the opacity. Never add mineral spirits to any plastisol ink.

TECHNICAL TIPS:To obtain other colors of Suede Plastisol, add 5-12% of any of Union Ink's Plastisol Toners (TOPL) to Suede Base (PLSE-9090). Adding more than 12% may result in an ink that will not cure properly. Suede Base is only intended to be used with Plastisol toners. It is not designed to be added to finished inks.

WASHUP: T-125 mineral spirits, or biodegradable washes SYS-2500, SYS-2550 or SYS-2510 screen wash gel.

ALWAYS TEST PRINT BEFORE PRODUCTION!

GAL
$ 39.71