Candoc ET Series 2-Part Epoxy

SPECIFICATIONS:

USES: For use on most ferrous and non-ferrous metals, glass, ceramics, treated polyethylene, phenolic resin parts and most other thermo-set plastics.

FINISH: Dries to a high gloss finish.

COVERAGE:Averages about 800-1200 sq. ft. per gallon.

OPACITY: Excellent opacity for most colors.

DRYING TIME: By the addition of the catalyst, the resins 'cross link' to produce a cured film. These inks will air dry in four to six hours at room temperature. These inks can be baked at a wide range of temperatures. Elevated temperatures will enhance the toughness of the film and increase the chemical resistance through more complete reaction with the catalyst, for example:

15 minutes @ 180°F----7 minutes @ 300°F

10 minutes @ 250°F----4 minutes @ 350°F

MIXING INSTRUCTIONS: Catalize in the ratio of five parts of color to one part of catalyst ET-6050 by volume. Catalyze enough for four to eight hours of printing at a time. Allow an induction period of one half hour before adjusting viscosity for printing. For certain 'difficult' substrates or for added flexibility and/or adhesion use ET-6055 Catalyst ET-E06 must be used when metallic powders are used. For simulated etch, mix 7 to 1.

SCREEN FABRIC: Use a 195 to 305 monofilament.

SCREEN COATING, FILM, BLOCKOUT: Direct and indirect photostencils, or water soluble, knife-cut stencils are suitable.

MODIFIERS: Thin with ET-6060. Under hot and dry conditions, use ET-6021.

FLOW AGENT: ET-6020

WASHUP: Use SYS-1925, or biodegradable washes 2500 or 2510 screen wash gel.