EACH - 7" DUAL EDGE PRO SCOOP COATER

One piece alloy construction with large emulsion resevoir and plastic ends . Features one edge with a round shape for thick deposits and the opposite with a sharp edge for controlled, thin emulsion deposition. Can also be custom made to specific lengths as required. Effective coating width is 1/4" less than overall length.

HOW TO USE:

FILL THE COATER: Under a safe yellow light source, pour emulsion from its container . Allow the emulsion to flow out to an even level. Make sure you have enough to coat in one stroke.

COAT THE SCREEN: Use the rounded edge of a scoop coater to apply an even coat of emulsion in one pass. The coater should be at least two inches shorter that the narrow width of your screen. Apply one coat of emulsion to the printing side, then one coat on the squeegee side. Dry the screen thoroughly.

Method 2:

CLEAN THE COATER: Scrape extra emulsion back into its container. Cover the container. Wash out remaining emulsion with water. Any remaining emulsion that dries in the coater can be very difficult to remove. Store the coater where the edged can't be nicked.