ROLL - 39X394" 15 CAPILLARY FILM

Premium all purpose Capillary Film for graphics, textile, electronics, and compact disc printing.

HOW TO USE:

HANDLING:Handle under yellow safelights. Avoid exposure to sunlight, flourescent and incandescent lights. It is important to remove any contamination, residual inks, cleaning chemistry, or general dirt and dust.

ADHERING THE FILM:Place the film on a build up board with the emulsion side up. The build up board should be slightly smaller than the inside of the frame.
Place the screen, squeegee side up, on top of the film. At this stage you can either use a spray bottle with water or direct emulsion to adhere the film.

WATER ADHESION

EMULSION ADHESION

DRYING: Dry the coated screen horizontally with the print side down in a clean light safe area. The following will help to ensure complete drying: 86° to 104° degrees F (30° to 40° C). 30% to 50% relative humidity with good air circulation

EXPOSURE:Clean the film positives and vacuum frame glass prior to exposure to minimize pinholes. Exposure is affected by mesh color, emulsion type, coating thickness, lamp type and the age of the bulb itself. For best results use an exposure calculator to determine the correct exposure time. It is important that a lamp designed for exposing screen printing emulsions is utilized

WASHOUT: Gently spray both sides of the screen with lukewarm water, wait a few seconds to allow emulsion to soften then wash print side of screen until image is fully open. Rinse both sides thoroughly and dry. The use of a drying cabinet or fans is recommended to dry the screen.

RECLAIMING: Use Screen Systems 2500 Series Ink Degradent to remove all excess ink from the frame. Remove the emulsion with Screen Systems 6000 Series Emulsion Remover.