GAL - 600 PROCESS CYAN PF

Four Color Direct Printing with a Very Soft Hand Feel

Now You Can Produce Realistic Prints with Ease!

600 Series Process Inks can be used for four color process screen printing. 600 Series should be printed on light backgrounds only. Excalibur Process Inks have a very soft hand feel.
600SS Series are highly pigmented process colors to make heat transfer prints. Ideal for glitter transfers and puff process transfers.

SPECIFICATIONS:

USES: 600 Series Process Inks can be used for four color process screen printing. 600 Series should be printed on light backgrounds only. Excalibur Process Inks have a very soft hand feel.

FINISH: Cures to a very soft-hand finish.

TRANSFER PRINTING METHOD:: Use 600SS colors. Always start by pre-shrinking the paper. Print the entire image area of the transfer with a 905/908PF Clear Transfer Base through a 110-230/inch mesh. After gelling the Clear Coat at 240°F-260°F for 30-60 seconds, proceed to print the 600SS Process Colors through fine mesh 230-350/inch. Process colors will gel at the same temperature as the 905/908PF Clear. The ink colors are printed and cured one at a time. Testing should always be done before beginning a production run.

OPACITY: Transparent

DRYING TIME: Plastisol inks will not air dry. They must be heat cured. 600 Series inks will fully cure and withstand repeated washings when the entire ink deposit reaches 310°F. Light colors may require longer periods to obtain this temperature.

SCREEN FABRIC: Use 60-110 monofilament polyester depending on the substrate for direct prints, 60-80 mesh for transfers.

SQUEEGEE: Medium Durometer (70) for direct prints. For transfers, use Medium to Hard Durometer (70-80) for 600 Series Process Colors; Medium Durometer (70) for 905/908PF Clear Base.

SCREEN COATING, FILM, BLOCKOUT: Use water soluble hand-cut, photo screens and blockouts with this ink or use other suitable products. A thick stencil or up to 200 microns is recommended.

MODIFIERS: A small amount of 502 curable reducer (1 to 3%) can be used to reduce opacity and soften hand. For direct prints, any amount of 501 reducer can be used to increase softness.

WASHUP: T-125 mineral spirits, or biodegradable washes SYS-2500, SYS-2550 or SYS-2510 screen wash gel.