GAL - COROPLAST RED #032 LEAD FREE

A high gloss ink formulated for corrugated plastic sheets

SPECIFICATIONS:

USES: Corrugated co-polymer resin sheets (e.g. Coroplast, Prime Cor-X, etc.) Good adhesion on some polypropylene, paper, card, etc.

FINISH: Dries to a high gloss finish.

OPACITY: Good opacity for most colors.

COVERAGE: Averages about 2,000 sq. ft. per gallon using 230 mesh monofilament.

DRYING TIME: CRP Series dries by evaporation. Prints normally air-dry within 30 minutes, or 30 to 60 seconds on a jet dry at 130°F. Overprints may require slightly longer due to rewetting of previous color. Ensure adaquate air circulation when rack drying.

SCREEN FABRIC: All fabrics are suitable; however, for optimum characteristics and good outdoor durability, use 200 to 250 monofilament mesh. Greatest opacity is achieved using 200 mesh monofilament or coarser fabric. For double sided or work requiring scuff resistance use 280 to 305 mesh monofilament and a sharp squeegee.

SCREEN COATING, FILM, BLOCKOUT: Direct and indirect photostencils, or water soluble, knife-cut stencils are suitable.

MODIFIERS: May be used straight from the can, but 5-15% thinning with CRP-1800 Thinner is recommended for optimum printing characteristics and leveling. CRP-1370 Extender should be used when conditions require greater transparency or color brilliance. Use CRP-1700 as a metallic base.

RETARDER: To improve screen stability, or under hot shop conditions, use some or all Slow Thinner CRP-1802.

DIE DUTTING / CREASING: Can be die cut, test before production.

WASHUP: Use CRP-1840 Washup or biodegradable wash 2500 or 2510 screen wash gel.