| SPECIFICATIONS:
USES: For
use on cottons, cotton/polyester blends, can be used on cold peel transfers,
and on nylon jackets (with Nylon Bonding Agent).
FINISH: Cures
to a soft-hand finish.
OPACITY: Excellent
opacity.
DRYING
TIME: 500
Series plastisol inks will not air dry. They must be heat cured.
500 Series inks will fully cure and withstand repeated washings
when the entire ink deposit reaches 320º F. Curing can be accomplished
with the use of a conveyor dryer, flash curing unit, or simple
infrared heater. Will semi-cure or gel at 250¾F for transfers.
TRANSFERS: Transfert
75 paper is recommended. For increased durability, use adhesive
powder or print 841 or 842 adhesive over the entire transfer.
Set transfer press for medium pressure for 10-15 seconds at 350º
F.
Peel cold.
SCREEN
FABRIC: Use
40-305 monofilament polyester depending on the substrate for
direct prints, 80-125 mesh for transfers.
SCREEN
COATING, FILM, BLOCKOUT: Use
water soluble hand-cut, photo screens and blockouts with this
ink or use other suitable products.
MODIFIERS: Use
small amounts of 502 reducer to achieve the look of a water based
print. Any amount of 502 curable reducer can be used to reduce
opacity and soften hand.
WASHUP: T-125
mineral spirits, or biodegradable washes SYS-2500, SYS-2550
or SYS-2510 screen wash gel.
ALWAYS
TEST PRINT BEFORE PRODUCTION!
|
