Excalibur Evolution is unique in that it represents an entirely new generation of textile screen printing inks. Evolution does not contain any PVC of phthalates. Unlike previous versions of PVC/phthalate free inks, Evolution will not dry in the screens, causing choking problems. It prints and handles exactly like conventional plastisol.

SPECIFICATIONS

USES: For use on cottons, cotton/polyester blends and most synthetics, can be used on cold peel transfers, see instructions

FINISH: Cures to a soft-hand finish.

OPACITY: Excellent opacity.

DRYING TIME: 4500/4550 Series plastisol inks will not air dry. They must be heat cured. Evolution inks will fully cure and withstand repeated washings when the entire ink deposit reaches 270° F to 280° F. Curing can be accomplished with the use of a conveyor dryer, flash curing unit, or simple infrared heater.

TRANSFERS: Transfert 75 paper is recommended. After printing and gelling the design, the entire print must be backed by 4841 Printable Adhesive.

SCREEN FABRIC: Use 40-305 monofilament polyester depending on the substrate for direct prints, 80-125 mesh for transfers.

SCREEN COATING, FILM, BLOCKOUT: Use water soluble hand-cut, photo screens and blockouts with this ink or use other suitable products. Make sure all are PVC/phthalate free.

MODIFIERS: Use small amounts of 4802 reducer (1% to 2%).
Do not use plastisol reducers or solvents!

WASHUP: Biodegradable washes SYS-2500, SYS-2550 or SYS-2510 screen wash gel.
STORAGE: Should be stored at temperatures less that 86ºF.

ALWAYS TEST PRINT BEFORE PRODUCTION