Triumph series represents a new generation of Plastisol Technology for direct and heat transfer printing onto nylon and high stretch fabrics. A true Single Part System. No hazardous chemical bonding agents need to be added. Triumph Series contains no solvents and will not air dry causing inks to thicken or block the screen. Triumph inks are phthalate free and contain no heavy metals.

SPECIFICATIONS:

OPACITY: Excellent opacity.

FINISH: Cures to a soft-hand finish.

USES:For use on nylon fabrics as well as high stretch fabrics such as Spandex and Lycra.

DIRECT PRINTING: For woven mesh use 200 to 255 mesh, 200 mesh or higher is strongly recommended. Heavy ink deposits are not recommended and will weaken the bonding strength of the ink film. For Lycra Spandex, use 80 to 160 mesh. Cure at 300 to 350°F. Curing should be tested to determine optimim belt speed and temperature. Prints must be fully cured for maximum bonding strength and stretch.

SCREEN COATING, FILM, BLOCKOUT: Use water soluble handcut, photo screens and blockouts with this ink or use other suitable products.

TRANSFERS: Transfert 75 paper or Transfilm clear is recommended. For woven mesh use 160 to 255 mesh, for Lycra Spandex, use 80 to 160 mesh. Print in the usual manner of a plastisol transfer, for increased durability use adhesive powder C57 over the entire transfer while wet, before curing through oven.Transfer presses should be set at medium pressure and tested for time and temperature before production.

MODIFIERS: Any amount of 3502 curable reducer can be used to reduce opacity and soften hand.

WASHUP: T-125mineral spirits, or biodegradable washes SYS-2500, SYS-2550or SYS-2510screen wash gel.

ALWAYS TEST PRINT BEFORE PRODUCTION